S01E03: XHTC / Design Improvements & Octoprint Preferences

Please watch: "Mailbag: How to control a RGB Matrix 64x32 Display via ESP32" https://www.youtube.com/watch?v=vScZ5BasUIc --~-- Hello friends,

here is another new video about the toolchanger on my Hypercube after a long time. Here's what I'll tell you:

how to download my design for the XHTC how to install the frame holder and prepare the tool holder how to set the preferences for the toolchange and of course some movements of the XHTC

Attention! I need your help, when I move from one extruder to the next, the new one will be cold. Now you will have to wait 5-10 minutes until it is heated up again. Would that be okay, or should I heat up the extruder to be changed beforehand? If so, how? I could perhaps heat the 24V cartridge with 12V, then maybe we would be at 120° instead of 180°.

Ok, your ideas about it are very welcome. Please type here in the comment section and I will answer every post.

Playlist of XHTC Series: https://www.youtube.com/playlist?list=PLYPTUTcLMTK7MkCJvDtKaIPH8B7HatVNU ... https://www.youtube.com/watch?v=xUQaVA273kA