#001 - Setting the Development Environment for NuttX

This is the first video of Getting Started to NuttX. I will explain what you need to getting started to NuttX using a low cost board powered by STM32F103 microcontroller.

These are the commands executed in the video:

apt-get install automake bison build-essential flex gcc-arm-none-eabi gperf git libncurses5-dev libtool libusb-dev libusb-1.0.0-dev pkg-config

mkdir ~/nuttxspace

cd ~/nuttxspace

git clone http://repo.or.cz/r/openocd.git

cd ~/nuttxspace/openocd

./bootstrap

./configure --enable-internal-jimtcl --enable-maintainer-mode --disable-werror --disable-shared --enable-stlink --enable-jlink --enable-rlink --enable-vslink --enable-ti-icdi --enable-remote-bitbang

make

sudo make install ... https://www.youtube.com/watch?v=heSkSd-_70g