DIY IOT weather station | Arduino | Blynk

$2 for 2-Layer PCBs & $5 for 4-Layer PCBs: https://jlcpcb.com

More project information(Code,Schematic,etc):- https://nematicslab.com/diy-iot-weather-station-arduino-blynk/

To add esp8266 boards in Arduino IDE software: https://nematicslab.com/install-esp8266-esp32-boards-on-arduino-ide/

Website, https://NematicsLab.com

Patreon, https://www.patreon.com/NematicsLab

For Sponsorships or Endorsements ONLY! Business@Nematicslab.com

For project-related questions use Facebook or Twitter @NematicsLab

Music used in the video:

1. Manhattan by Dyalla
2. Midnight Prophet by Sarah, The Illstrumentalist

---------- Affiliate ----------

Gearbest- http://bit.ly/2KD54KD Banggod- http://bit.ly/2xgJIK5 LCSC - http://bit.ly/2KD0hJ0

---------- Social Media ----------

Facebook - http://bit.ly/2FC5lJz Instagram - http://bit.ly/2XddQpe Twitter - http://bit.ly/2IUhqMm

--------------------Electronics Starter kit Tools-------------------- Soldering Iron - https://www.banggood.in/custlink/DKGKUAqCKa Solder wire - https://www.banggood.in/custlink/mv3vks2ROf Helping Hands - https://www.banggood.in/custlink/vmvmMAqd0C Hot Glue - https://www.banggood.in/custlink/D3GDMAkWDS

----------------Little information about Video------------------- This project is related to initial steps in IoT world, here we will interface DHT11/DHT22 sensor with NodeMCU or other ESP8266 based board and receive data on internet we are going to use Blynk application, use the following tutorial link if you are not familiar with blynk application.

For Blynk (it require only few minutes): https://docs.blynk.cc

After this you are require to add esp8266 boards in your Arduino IDE software, use following link

There are simple hardware connections, you are not going to deal with any messy connections, so recreate & enjoy this project. ... https://www.youtube.com/watch?v=zqUevK-NKF4