⚡ 4 Easy Ways to BLOW UP Your Test Gear ⚡

⚡ How to avoid damaging your test equipment! ⚡ Free 📋 ESD Checklist Download: http://bit.ly/ESDChecklist Click to subscribe! ► http://bit.ly/KLabs_sub ◄

Here are four (actually seven!) easy ways to blow up or damage your oscilloscope, signal analyzer, spectrum analyzer, vector network analyzer, DMM, power supply, function generator, or pretty much ANY piece of test equipment you may come across. It's surprisingly easy, and you can damage your gear without ever feeling it!

Electrostatic Discharge (ESD) protection measures are no laughing matter when it comes to dealing with sensitive test equipment.

Helpful Links:

Keysight Bench Facebook page: https://www.facebook.com/keysightbench

Keysight RF Facebook page: https://www.facebook.com/keysightrf

EEs Talk Tech Electrical Engineering podcast: https://www.eestalktech.com https://www.youtube.com/KeysightPodcasts

Check out our blog: http://bit.ly/KeysTechBlogs

Twitter: @DanielBogdanoff: https://twitter.com/DanielBogdanoff

Today we’re going to look at 4 easy ways you can blow up your test gear with ESD or the wrong inputs. It happens to people all the time. Electronic damage to test gear is caused by an excessive amount of power going into an equipment’s inputs, and that power gets there a few different ways. If you want to blow up your test gear, follow these tips.

#1: Apply overvoltage to the equipment inputs The easiest way to blow up your test gear is to hook up any signal without knowing it’s characteristics. Sure, test gear’s data sheets list the maximum input parameters. And sure, equipment has built-in protection mechanisms and will often warn you if you are outside the spec. To avoid blowing up your equipment this way, don’t exceed the maximum input power or voltage on your gear. Also, when connecting to an unknown signal, start at the lowest sensitivity and work your way down to the signal. Essentially, you always want to keep your signal completely on screen.

#2: Float yourself - As you can see with the ESD meter, an ungrounded person (or a person with a wireless ESD band) can have charge. The charge can then be transferred right into the equipment, or to an ungrounded conductor. Then, when this board is connected to equipment it can damage the gear. To avoid damage, make sure your mat is properly grounded and use corded ground straps. Note that wireless ESD bracelets (also known as wireless ESD straps and wireless ESD wristbands) DO NOT WORK!

#3: Charged Boards - If you aren’t careful, your boards can charge up via induction, and then zap your gear. To avoid this damage, keep charged materials at least a foot away from your boards and use appropriate materials. If you’re transporting boards, you should also completely seal them up in static shielding bags so ... https://www.youtube.com/watch?v=dDvue5whx0s